First, check whether the interfaces are complete.
The most basic input and output interfaces that an AV amplifier should have should include the following: coaxial, optical fiber, and RCA multi-channel input interfaces for inputting digital or analog audio signals; speaker output interfaces for outputting signals to the speakers.
Second, check whether the surround sound formats are complete.
The popular surround sound formats are mainly DD and DTS, both of which are 5.1 channels. Now these two formats have developed into DD EX and DTS ES, both of which are 6.1 channels.
Third, check whether the power of all channels can be adjusted separately.
Some cheap amplifiers divide the dual channels into five channels, and the channels can be large or small, while each channel of a truly qualified AV amplifier can be adjusted separately.
Fourth, check the weight of the amplifier.
Generally speaking, you should try to choose a heavier model. The reason is that heavier equipment has a stronger power supply. Most of the weight of the amplifier comes from the power supply and the chassis. Heavier equipment means that the transformer used is larger or the capacitor with larger capacity is used. These are ways to improve the quality of the amplifier. Secondly, the chassis is heavier. The material and weight of the chassis have a certain degree of influence on the sound. The chassis made of certain materials are helpful for isolating the circuit inside the chassis from the radio waves scattered outside. The higher weight or more stable structure of the chassis can also prevent the equipment from being affected by unnecessary vibration and affecting the sound. Third, heavier amplifiers are usually made of richer and more solid materials.
Power is the most important parameter in the audio system, indicating the ability of the audio system to carry load. This is also the first thing we should pay attention to when purchasing. However, if each manufacturer uses different measurement benchmarks to identify product performance, it is often difficult to make an objective comparison without sufficient understanding. The same is true for amplifiers. When checking the amplifier power logo, you should pay attention to the following three points:
First, battery voltage.
The voltage of the car battery changes frequently. For the two commonly used power amplifiers marked with 14.4V/100W and 12V/100W, they are two completely different power descriptions. Since the voltage of the car is basically around 12V during driving, the power value measured at 12V voltage is closer to the actual situation. Moreover, the power amplifier marked with a continuous voltage of 12V can achieve greater power when it reaches 12V or above.
Second, the harmonic distortion rate THD.
When comparing the continuous output power of the power amplifier, it is necessary to do it at the same (or relatively close) THD value. The difference in sound quality tested under different THD values is very obvious. Sometimes the maximum power marked is very high, but it is very likely that its distortion and noise are also very high. Therefore, when checking the maximum power, you should also pay attention to the THD value marked.
Third, the frequency range.
The continuous power output of the power amplifier should be tested within the frequency range it actually uses. For the power of the power amplifier, the complete detection range should be marked. It is meaningless to mark the power value when only a certain frequency is marked. After determining the same benchmark, we can compare the power of the amplifier. Usually, when purchasing an audio system, the principle of high power output is generally followed. The greater the output power of the amplifier, the stronger its ability to drive the speaker. The power of the amplifier should be greater than the indicated power of the speaker. If the power selected is too small, it is easy to burn out when using high power output for a long time, and it will also cause faults such as poor sound quality and distortion.
