1. To ensure that it is used within a safe voltage, it is best to use a 220V AC regulated power supply or a DC high-voltage regulated module.
2. The error between V+ and V- should not be greater than 1V, and the positive and negative power supplies and ground should be firmly welded. Only turn on the power after welding is completed and confirmed to be correct.
3. In the initial stage after the power amplifier IC is powered on normally, its stability is poorer than that of discrete component amplifiers. Therefore, it must be "burned in" or played at a low volume for at least 10 minutes before it can stably and efficiently exert its excellent performance.
4. When making a power amplifier, the grounding should be strictly enforced. It is better to use multiple strands of thick copper wire as the ground wire. You can even use a double-bridge rectifier with floating ground technology to maximize its signal-to-noise ratio.
5. If the local power grid is seriously polluted and the low-voltage power grid is connected to electrical equipment such as welding machines and silicon rectifiers, a power filter can be used. If the pollution cannot be eliminated, a power isolation transformer can be used, but there must be enough power.
6. Pay close attention to the switching order of audio equipment. For amplifiers made with Hi-Fi amplifier ICs, remember to turn them on last and shut them down first.
7. Before installing a newly purchased power amplifier IC on a computer, it is best to use a socket, do not solder, and secure the heat sink. If it generates severe heat after power is turned on and outputs DC, remove it and return it to the mail order unit.
8. In order to prevent the amplifier IC from outputting DC that can damage the speakers, be sure to install a speaker protector.
9. The system equipment must be well grounded. Due to the asymmetric three-phase load of the low-voltage distribution line, the neutral line will be energized, and after being connected to the ground, the potential is zero, which is very beneficial to improving the signal-to-noise ratio. The method is: use a ∮10mm long 1.5m round steel, weld it with 2.5mm2 multi-strand copper wire (do not rivet or wrap it), and insert it into the outdoor wet ground.
